X▒Xcmdline str: rootloc=512k rootsize=64k dataloc=2688K datasize=128k mem=35M videomem=16M fbmem=13M console=ttyS0,115200 init=/init .
mem_info bank[0]start:90000000, size:2300000.
mem_info bank[1]start:92300000, size:1d00000.
The whole mem size: 4000000.
wdt_init, 6131.
jedec_id=1c7017, ext_id=1c70
read tmp_status[0,1] 10,8
USB HCD: device gx-ehci, build at  10:16:21 Feb 26 2020
ehci: 0x905024ec
gx-ehci gx-ehci.0: gx EHCI
gx-ehci gx-ehci.0: new USB bus registered, assigned bus number 1
gx-ehci gx-ehci.0: irq 59, io mem 0xa090000000000000
hub 1-:1.0: USB hub found
hub 1-:1.0: 1 port detected
hub 1-:1.0: individual port power switching
hub 1-:1.0: Single TT
USB HCD: device gx-ohci, build at  10:16:22 Feb 26 2020
gx-ohci gx-ohci.0: gx OHCI
gx-ohci gx-ohci.0: new USB bus registered, assigned bus number 2
gx-ohci gx-ohci.0: irq 58, io mem 0xa0a0000000000000
goxceed vserson v1.9.6-4+patch
MPEG: date 0000.00.00 ver 0.0.0.0
[FB]:start:0x92300000, size:0x1d00000
cramfs_open() error:cramfs is readonly filesystem
can not open file /home/gx/config.ini
can not open file /home/gx/config.ini.bak
fe_profile.demod_type = 5
fe_profile.demod_i2c_id = 2
fe_profile.demod_chip_addr = 0x18
fe_profile.tuner_type = 56
fe_profile.tuner_i2c_id = 0
fe_profile.tuner_chip_addr = 0x74
DEMOD, tuner register
r836 attach... 0x905262c4
GetDmHeadInfo ----------688, i:0, 0xaf50104, 0x9134, 0x10000, 0x5b045720
GetDmHeadInfo ----------688, i:1, 0xaf50105, 0x2040b, 0x30000, 0x558e66e
GetDmHeadInfo ----------688, i:2, 0xaf50106, 0x8354, 0x10000, 0xcc12d27a
[FB]:start:0x12300000, size:0x1d00000
framebuffer phys = 92300000, mmap = 0x92300000, size = 30408704, mgr = 0x92300000
DVB: initialising frontend (Nationalchip GX1001 DVB-C)...
the 0x0030A200 start reg 7283
r836_init success
[gx1001]fre:330000000,symbol_rate:6900000,qam= 3
r836_set_params fre = 330000000
set inversion tuner type = 56
gx1001_get_equ error val = 0x0
[HOTPLUG] PLUG_IN: /dev/usb0, 1 partition
[HOTPLUG] add device /dev/usb0
[HOTPLUG] add partition /mnt/usb01